I need help Finding AWG #4 cables

That does seem kinda big. Even for a run of 60 foot. Were only talking about 17 amps right?
There should be an electrical supply house somewhere near you that will cut the lengths you need. Electrical contractors need to have some sort of supplier. Check the yellow pages. Will THHN work? As for the color, while your there tell them you need some red and green tape and you can tape each end of the same wire.

Hi Tom Allen... I got a 3, 60 foot #6 AWG.

On Page 10 and 11 of the Air-X manual, the chart is what I was rilled up about.

24 volt 400 wat Air-X at average wind speed 12mph
0-30ft 14awg | 30-60ft 12awg | 60-90ft 10awg

Numbers are much different for the 12volt version.

Page 11 Wireing Compensation for Average Wind Speed

Average wind speed | Multiplier for Wire Lengths
9mph | 2
10mph | 1.5
11mph | 1.25
12mph | 1

The average wind speed in my area is right around 8 or 9mph.

You're an expert on this right? or fairly knowledgable. That sounds bare minimal right? Mulitplier is 2, so 12awg multiply wire strength = #6awg.

I ordered another pure sine inverter... says it's back ordered :/ 12 volt 150watt samlex. The cable I got from a nice guy on ebay, lucky I found some someone who sold AWG #6.

Now the main project I have left is extending my chembuster, which will take a while to save up for. I'm pretty much prepared for the crash, got some food growing, got solar and wind generators, got a chembuster to stop the sylphs in the planes (chemtrails), got water filters to filter flouride and other mind control chemicals... Yep I feel great that I'm prepared. Still a few other things I'd like to get. Anyways a big thanx to AltE. I suscribed to their channel on youtube.

Take care guys, and Thomas Allen, let me know what you think, #6 AWG sounds good according to the specs right? thanx, later guys.