charge controller with Ametek permanent magnet motor

Posted by Joe Wood on June 17, 2004, 05:16:00 PM

charge controller with Ametek permanent magnet motor
Hello,
I am putting together a microhydro system using a 20V Ametek permanent magnet
motor with a waterwheel. I need a charge controller, blocking diode and heat sink but I'm not sure which specific type/brand of these components to get for the system. I expect to produce around 50-200 watts
depending on the flow of the stream.  I plan to use 2 Trojan T-105 batteries along with a 2000watt inverter to power a small RV.  Does anyone have an idea of which components would be best suited for my system?
thanks
joe

 
Forums | Design by Scratchmedia | Development by SMF.
© 2001-2005, Lewis Media. All Rights Reserved.

Disclaimer and Disclosure

The Alternative Energy Store, Inc reserves the right, within its sole discretion, to refuse or delete any posting or portion thereof, or terminate or block the access to this forum.

The opinions and statements posted on this forum are the opinions and statements of the person posting same, and do not constitute the opinion or act of the Alternative Energy Store, Inc (AltE). The Alternative Energy Store, Inc does not endorse or subscribe to any particular posting. No posting shall be construed as the act or opinion of the Alternative Energy Store, Inc.

Need help selecting components?
Call Us Toll Free!
877-878-4060

Se habla Español

cart

0 items

latest posts

more »
 

top members