Enough collector area for domestic HW and hot tub + heat exchanger questions

Posted by Elbie Yates on September 22, 2008, 04:38:38 PM

Re: Enough collector area for domestic HW and hot tub + heat exchanger questions (Reply #5)
Thanks everybody for the replys so far...

The hot tub does not have a heat exchanger per say. But then again, it doesn't really have much of anything until UPS delivers all the stuff..

I'm torn between trying to make my own heat exchanger, or buying one, but either way I go, I'll use the hot tubs internal circulation pump to feed one side of the exchanger, and the solar pump would run the other... I'm thinking that if I bury the pipe 12 inches, it should be protected from what we get as a "freeze", the hot tub has a freeze protect mode, which would keep warm water through the heat exchanger....

All the thinking about the amount of valves required is making my head hurt..

Elbie
 
Forums | Design by Scratchmedia | Development by SMF.
© 2001-2005, Lewis Media. All Rights Reserved.

Disclaimer and Disclosure

The Alternative Energy Store, Inc reserves the right, within its sole discretion, to refuse or delete any posting or portion thereof, or terminate or block the access to this forum.

The opinions and statements posted on this forum are the opinions and statements of the person posting same, and do not constitute the opinion or act of the Alternative Energy Store, Inc (AltE). The Alternative Energy Store, Inc does not endorse or subscribe to any particular posting. No posting shall be construed as the act or opinion of the Alternative Energy Store, Inc.

Need help designing your system?
Call Us Toll Free!

877-878-4060

Se habla Español

cart

0 items

 

top members